Anchorage and End Fittings

Tendon Systems offers a wide variety of standard end anchorages and specialized end fittings.  Each anchorage is designed to handle the full guaranteed ultimate force of the cable although the actual design load is much lower than this.

Standard end anchorages are utilized where access for stressing is available on the back side of the terminating support.  These anchorages may be either recessed into a concrete column or wall or surface mounted.

Specialized end anchorage components are available where access is not available on the back side of the cable termination.   The end anchorage fittings and components may be protected through hot dip galvanizing (ASTM A153) or zinc plating conforming to ASTM B633.

 

All end anchorages and specialized end fittings allow for back stressing, an installation requirement of the Post-Tensioning Institute (PTI).